Usage
Non-absorbent interfacial agents are used to treat non-absorbent and non-porous or smooth surface substrates.
Characteristic
Environmental protection type;
Short waiting time;
Construction is simple;
Economical and practical, large coating area;
Suitable for heating floor base.
Applicable base
Suitable for non-absorbent, dense or smooth surface base, such as stone, water ground SLATE, ceramic tile, rolled concrete, asphalt and wood surface base. It can also be used in geothermal systems with a maximum temperature of 50℃. But for too much dust, brittle surface, metal sawdust board and magnesium oxide, calcium sulfate base, this product should not be used, and M320 can not be used as a moisture-proof course. This product can only be used indoors.
Construction Method
1. Non-absorbent interface treatment agent does not need to be mixed with water, ready to use.
2. Before use, shake the container evenly and then open it for use.
3. Be careful not to pour the product directly on the base, it should be poured into the roller tray first, and then coated evenly and thinly with the wool roller, and be sure to avoid the accumulation of liquid. The next step can be carried out after the interface agent is thoroughly dry.
Technical Specification
| Color | white |
| State | liquid |
| Solid content | ≥35% |
| Density | 1.0kg/L |
| Storage condition | + 5 ~ + 35 ° C; Frost protection |
| Thousand nations time | About 12 hours (Actual condition depends on site temperature and humidity |
| packing | 20kg/ barrel |
| dosage | 180-200 square meters per barrel |
Base Treatment
The construction surface should be solid, no structural damage, have enough compressive strength, flexure strength, smooth, dry, clean, no cracks, no grease and release agent and other chemical additives. If the surface of the base is loose or large area of floating slurry, it should be shot peening treatment. Before construction, it is recommended that all mineral bases be tested for moisture content. In the high moisture content of the base, especially new buildings, need to do moisture-proof treatment. Polish the base and vacuum before coating.
Note
Non-absorbent interface treatment agent is a special interface treatment product of environmental protection, non-flammable and low volatility. The optimal construction environment is the temperature above 15℃ and relative humidity below 75%. Ensure that the construction site is well ventilated.
Packaging and storage
20kg plastic bucket packing. This product must be stored indoors at 5℃ -35 ℃ to prevent freezing and exposure. The shelf life is 12 months.