Absorbent Water-based Interfacial Agent
Absorbent water-based interfacial agent uses high quality special structure acrylic copolymerization synthetic emulsion, has the characteristics of fine particles, moderate viscosity, tough film, strong adhesion to the substrate, good alkali resistance, at the same time has strong sealing property and good weather resistance.
Technical Specification
Appearance | White Emulsion with blue light |
PH:(25°C) | 7+1 |
Solid content | 48土2 |
The minimum film forming temperature | 5°C |
Transport and storage temperature | 5℃ to 35℃ (prevent frost) |
Allowable temperature after curing | Maximum 50℃ (can be used for heating floor) |
Package | 5 kg /10 kg plastic bucket |
Storage | 12 months under normal conditions |
Usage
It is used to close the pores of the base to the absorbent ground and enhance the adhesion and adhesion of the base. It is an important treatment agent in the construction of self-leveling cement and other materials.
Characteristics
Environmental Protection. No organic solvent.
Faster consolidate,Increase boundary adhesion.
Strength coating, Strength closure
Excellent resistance to alkali, Excellent weather resistance
Applicable base
The base must have a suitable structural moisture barrier. If the residual humidity is too high, especially in a new building, you may need to install a moisture-proof film.
The base must be free of structural defects, that is, have appropriate compressive and flexural strength. The base is dry, with no impact on adhesion and slurry, dust, or contaminants. If there are defects on the base surface, mechanical treatment is needed on the base surface.
Construction method
For absorbent concrete base, can be directly brushed without dilution. For plaster or cement/mortar base, diluted with clean water in a maximum ratio of 1:1, cross roll coating twice. High absorption base may require more than two rolls.
Do not pour the product directly on the base, should be slowly poured into the drum groove or bucket. Use medium size suede roller to brush on the treated base. Coat the entire area evenly. Avoid fluid accumulation. It should be air-dried before proceeding to the next process.
Warning
Do not pour directly into the drain. If it has expired. Handle in accordance with local regulations.
Health and safety
Solvent-free, non-combustible, safe when used correctly, and frost-proof when stored, transported and used. Wear appropriate personal protective equipment, such as gloves and goggles, when necessary.